Litton (Corse) Front Suspension Question

[Two-Eight-Six]

Ford Granada Scorpio as used by Corse "I", Ultima & Gd.
Inner haxagonal drive is not required, simply hold across the studs a. Ice & tighten the but on the other side in a vice.

Thanks for being so prompt replying, Craig - I read this as meaning you have to remove the upright containing the bearing, complete, then locate it in a vice, where there's a nut accessible on the reverse side you can tighten-up while it's being held in the vice? (Is that correct, and what size is that nut?

Thank you again…..

[Strat Fan]

I've reworded my post above so that it reads in English this time! (apologies for the confusion, I will revert to using the computer for typing rather than the mobile!)
I don't know what size the nut is as it's a few years since I've assembled that type of upright.