WANTED: 100 mm electronic speedometer

[hollytree]

Thanks. Do you have an image of the one you bought and the hole dimensions.
I think i might struggle with the row of switches I have.

It is fake carbon fibre stick on mine. If it was aluminum underneath i would peel it off, but I dont want to start and make a mess if not.
Has anyone else go any of this stuff and what is under the fake carbon skin

[Two-Eight-Six]

Thanks. Do you have an image of the one you bought and the hole dimensions.
I think i might struggle with the row of switches I have....n

Here's a pic of what Hawk supply - it's reversible so my photo shows the reverse, LHD version. Imagine it turned around for RHD - I've shown it like this as the other side has protective film to protect pre-installation.

You trim the rectangle so it matches whichever manufacturer's pod or pinnacle is yours - I guess they all vary. Holes are 100 mm for the two principal gauges & 50 mm for the lesser.

Hope that's helpful - Gerry has them in stock.

[Two-Eight-Six]

And the photo is upside down, for antipodean readers

So that's wrong way round & upside down. (Hang from the ceiling & rotate, to visualize it in your own car...)