Hawk Suspension Washers

[ProtoTipo]

Wanted:

Hawk special large diameter thick 1/2" UNF clearance steel washers.
That go either side of the old type inner suspension arm bushes.

[hollytree]

Chris.
I bought lots of stuff from these people when I did my car. Maybe try them
https://www.westfieldfasteners.co.uk...l-Washers.html

[ProtoTipo]

Thanks Steve,
There's one or two on there that might be right, but I need to know the thickness and diameter of those supplied in the kit.

The washers were supplied with early Hawk (Transformer) kits. Gerry says that they were probably machined up.
The washers have not been part of the Hawk spec. for a long time now.

[STR_Strat]

Hi Chris, happy to machine some for you if you can find the dimensions, I should have a bit of stainless kicking around.

Dave

[pab56]

Front or rear suspension ? I can check as they are probably fitted to SAR518R it still has original Transformer suspension.

[ProtoTipo]

Hi Chris, happy to machine some for you if you can find the dimensions, I should have a bit of stainless kicking around.Dave

Thanks for the offer Dave, but I can make them if I need to.

Front or rear suspension ? I can check as they are probably fitted to SAR518R it still has original Transformer suspension.

Thanks Paul,
If you could have a look at the washers on the rear (photo of my old orange car attached). Although now that I've found that photo, I could probably scale it from that.
If possible could you see roughly what type of washers are either side of the front lower arm bush? I'm sure there must be some, but I've never worked on the front end of a car with the older type bushes, 'only had the rear in bits.

Thanks for the help, both.

There's no mad rush with this. It's just that I'm putting the suspension wheels and steering on the car, temporarily, to move it to the painters. Fitting the suspension together just reminds me of any bits and pieces I need to sort out, and/or are short of.