Lancia Busso engine Plennum Cover wanted

[ProtoTipo]

Could someone give me these 24v dimensions?
(I've got a 12v one here)

[ProtoTipo]

I can draw in .dwg or .dxf, I just need the overall dimensions.
To complicate it, you could have the capacity of each:

LANCIA 2.5 24v
LANCIA 3.0 24v
LANCIA 3.2 24v

LANCIA 3.0 12v

or

LANCIA V6 24v
LANCIA V6 12v
LANCIA V6

[hollytree]

Or
LANCIA V6 STRATOS

[mariner]

Hi Chris,

Just measured a V6 24V and a GTA 3.2 V6 plennum and got same measurements for each one - 75mm x 370mm

rgds Bob

[ProtoTipo]

Hi Chris,

Just measured a V6 24V and a GTA 3.2 V6 plennum and got same measurements for each one - 75mm x 370mm

rgds Bob

Thanks for that Bob.

[ProtoTipo]

2 slightly different typefaces:

[Guy Mayers]

I think the top one you've pictured is from the Lanca Kappa Coupe V6 Chris. Lower one is from the Thesis. Neither is commonly available....

[hollytree]

The plenum and the front valve cover on the 164 12v engine I bought from Enzo. The letters appear to be machined in about 1/2 mm deep

[Guy Mayers]

And nailed on the wrong way round compared to the others... Not that it really matters!

[hollytree]

And nailed on the wrong way round compared to the others... Not that it really matters!

Never thought before, but now that you mention it...
Reads the right way when you open the clip and look at the engine from the rear of the car. Someone must have made a conscious decision to machine it that way