Lancia Busso engine Plennum Cover wanted

[hollytree]

It takes that same type of TB that Rob Sanderson's Kappa 24v had.

The thing is, the part with the LANCIA lettering looks like a separate part, (even though it isn't). So why not have some plates CNC'd to look the same, then bond them to Alfa plenums?
Club purchase?

Good idea, but that does not officially count as "regalia"

Halifax WaterJet would just cut these in whatever metal wanted if they have a CAD file https://www.waterjetuk.com/
They can do dozens at the same time out of a single sheet. i have seen them in action and it is very impressive

[ProtoTipo]

Good idea, but that does not officially count as "regalia"

We could get some done in gold, to hang round the neck?

[ProtoTipo]

Could someone give me these 24v dimensions?
(I've got a 12v one here)

[mariner]

Hi Chris,

Just measured a V6 24V and a GTA 3.2 V6 plennum and got same measurements for each one - 75mm x 370mm

rgds Bob

[ProtoTipo]

Hi Chris,

Just measured a V6 24V and a GTA 3.2 V6 plennum and got same measurements for each one - 75mm x 370mm

rgds Bob

Thanks for that Bob.

[ProtoTipo]

2 slightly different typefaces:

[Guy Mayers]

I think the top one you've pictured is from the Lanca Kappa Coupe V6 Chris. Lower one is from the Thesis. Neither is commonly available....

[ProtoTipo]

I can draw in .dwg or .dxf, I just need the overall dimensions.
To complicate it, you could have the capacity of each:

LANCIA 2.5 24v
LANCIA 3.0 24v
LANCIA 3.2 24v

LANCIA 3.0 12v

or

LANCIA V6 24v
LANCIA V6 12v
LANCIA V6

[hollytree]

Or
LANCIA V6 STRATOS