I'm getting some more Stratos / Fiat Dino Coupe front indicator housings 3D printed in plastic.
I haven't had a chance to sort the concave bulb reflector, lens or rubber gasket so I cannot supply those yet.
If required, I can fit a bulb holder and two wire seals (rather than a boot) to the rear too if required.
Please PM me if you would like any housings and if the bulb holders are required and I will come up with pricing. Originals are extremely rare and expensive !
Original housing with chrome reflector and rubber boot
3D printed housing in slightly textured grey plastic with brass screw mounts for the body and lens (vapour smoothed black finish is also possible)
Reply With Quote
Bookmarks