I've never overtightened them Andrew, just used new nylocs each time they're overhauled. It's a really important job to do as the bushes can rust onto the rod and that's a pig of a job to sort out!!! Never want to do that again!!
Guy
Hi,
I decided to strip the front upper suspension arrangement last week and re-grease etc.
This is top wishbone, pivot rod end with spacers, shock absorber top mount etc..
All good and I re-assembled.... The one thing I'm not sure on is how tight the whole think needs clamped together.
If it's not too tight, I guess the rod will move and if it's too tight it's maybe too much pressure on the bushes. (I can't remember what I did 9 years ago !)
At the moment it's all "FT", but thought I'd check and see if there is a correct way of torquing this lot up??
Any advice, much appreciated.
Cheers
Andrew
I've never overtightened them Andrew, just used new nylocs each time they're overhauled. It's a really important job to do as the bushes can rust onto the rod and that's a pig of a job to sort out!!! Never want to do that again!!
Guy
Last edited by Guy Mayers; 16-12-2016 at 17:19.
do you take the rod through the cabin? I am about to do this strip on mine so any tips would be helpful.....
No Tim - out the front. Whatever you do do not resort to using a hammer on either end of the rod or you'll spread the end and then you're in trouble...
Undo the inner end and then tighten the outer to draw the rod through slightly, then try using the spanner to pull the rod out. If it just loosens the nut take it off and pack it with washers and retighten drawing it out further. Repeat until it's free enough to pull out.
If it's seized somewhere you've got to identify where and there are only two places. Either the rod is seized in the chassis bushing or the suspension arm bush is seized to the rod.
Should you find that the bush is rusted to the rod then you might get it out with releasing fluid and time but if that fails AND you know that the rod moves in the chassis bushing you can remove it by cutting the rod through on either side of the shock absorber. That ought to give you enough clearance to remove all the remains.
If it's seized in the chassis bush I suspect it'll need cutting and drilling out by someone who really knows what they're doing!
Guy
Thanks Guy.
Thanks Guy,
Sounds like I should slacken off a bit then...
Came apart Ok, but they are a bit of a sod to get out and back in again.
I'd anticipated difficult times, so I ordered a couple of new rods from Gerry... £20+VAT + delivery... Put them in and all good as new now :-)
Thanks
Andrew
They can be a pig to reassemble but always regrease the rod before putting it back in. I usually put a glob or two into the chassis bushing and then work it through a few times with the rod until it all moves freely.
Putting the rod back through the various spacers, suspension top mount can be a little fiddly on your own but I use a cut down bolt with slightly chamfered ends that can be slotted into the chassis with the shock, spacers and washers pre assembled on it and then pushed out with the rod. Simples.
Guy
Any photos of this process, anyone?
With a Hawk;
don't tighten the suspension up until it's been bounced on the ground.
Especially with the older metalastic type bushes.
In other words, don't tighten it up in droop.
Nope sorry! It's a right faff putting it all together without throwing juggling a camera in there! If you don't understand the process I'm describing drop me a PM and I'll send you my phone number to discuss?
Guy
Bookmarks