Andrew,
The 12 valve Busso will go in the four pot cradle with minor mods. I remember that Dave Watson managed to drop a 24v in, but had to alter the rear frame of the cradle rearward slightly.
For the 12v it was engine mounts ( obviously), and re-position bracing in the rear frame to accommodate the rear bank headers.
Someone had ( badly) repositioned the diagonal tube which comes up from the side pontoon to the top strut mount, but I got it back more or less where it should have been during a general tidy up of chassis.
Sorry, long winded reply as usual.
The answer is yes, more or less!
"I" chassis is of course very different and was specific to the engine being installed. Your Honda engine chassis being better than the Alfa variety in my opinion.
Steve Ellis adapted his Honda engined chassis to accept the MG/Rover V6, but an Alfa would have been unviable.
Reply With Quote
Bookmarks