Hi Phil,
I don't have one to offer, but EPER lists it as 73500482 for the princely sum of £10.63 inc VAT and claims it is 'orderable'.
HTH
Does anyone have a clutch slave cylinder mounting bracket?
must be
Alfa 156
2.5 v6
manual.... Obviously !
cheers
Phil
Hi Phil,
I don't have one to offer, but EPER lists it as 73500482 for the princely sum of £10.63 inc VAT and claims it is 'orderable'.
HTH
Phil
If you do not find I will go on monday to the breaker close to me where I picked up recently 2 wiper motors on Alfa's 156 and if they are still there I could have the part may be
Then will send it to you immediatly
Just drop a message
166 type fits as well.
Hi Chris /Michel....
I have fitted an Alfa 3.0 24v 6 speed to Nellie but I am using the LB cable selector system....the only issue is that the existing clutch slave cylinder bracket will not fit without major rework but apparently the 156 v6 should bolt straight on.... It's me being idle !....thanks for your input... Phil
I've got a spare one, more than happy to post it. My LB gear selector assembly needed a big chunk chopped out of it to fit around the cylinder and bracket properly.
Paul.
Sat in a real one, may never wash again!
Paul... I take it you also have the 166 6 speed box as well so appreciate the problem..
No I've got the 156 6 speed, I would've thought they'd be pretty much the same?
Paul.
Sat in a real one, may never wash again!
The gearboxes may well be the same...I don't know..... But the slave cylinder mounting on my 166 6 speed won't allow the slave cylinder to be in the correct position to actuate the clutch lever due to fouling the linkage system.... Craig showed me a bracket that was off a 156 that solved the problem...I could carve the existing bracket to make it fit but would look very Heath Robinson if my welding is anything to go by !!...lol
Bookmarks