Stratos / Fiat Dino Coupe front indicator housings

Printable View

12-12-2025, 13:24
Azzo42

2 Attachment(s)

Stratos / Fiat Dino Coupe front indicator housings

I'm getting some more Stratos / Fiat Dino Coupe front indicator housings 3D printed in plastic.

I haven't had a chance to sort the concave bulb reflector, lens or rubber gasket so I cannot supply those yet.

If required, I can fit a bulb holder and two wire seals (rather than a boot) to the rear too if required.

Please PM me if you would like any housings and if the bulb holders are required and I will come up with pricing. Originals are extremely rare and expensive !

Original housing with chrome reflector and rubber boot

Attachment 24526

3D printed housing in slightly textured grey plastic with brass screw mounts for the body and lens (vapour smoothed black finish is also possible)

Attachment 24527

All times are GMT +1. The time now is 03:43.

Powered by vBulletin® Version 4.2.5
Copyright © 2025 vBulletin Solutions Inc. All rights reserved.

While every effort is made to moderate these forums, occasionally inappropriate comments may appear from other members. These comments are not necessarily the views of the owners or operators of Stratos Enthusiasts Club Form. The owners, operators and partner sites of Stratos Enthusiats Club Forum cannot be held responsible for other user's views. Anyone using these forums does so at their own discretion. If you feel a post by another user is inappropriate to appear in a public forum please report the post to the forum moderators who will act as soon as possible and as they see fit. However posts remain the sole responsibility of the member who submitted them. All copyright and other intellectual property rights in the materials on the Online Community are owned by the Stratos Enthusiasts Club unless otherwise indicated. The copyright in any contribution posted by registered users of the Online Community shall belong to the person making the contribution.