444 Series rocker switches

[hollytree]

When I built my car, I used these 444 style rocker switches.
Over winter I plan to take out the fake carbon fibre dash panel (no laughing) and use some aluminium sheet.
Waterjet at Halifax will make a CAD file of the old panel and cut a new one, but I would like to get some of the switches I used before as the loom is all made up with the correct plug blocks to suit each switch confiruartion.
I think they used to be called Britax switches, now appear to be Ionnic.

Does anyone know where I can but these as I require a range of different functions (2 speed fan, front fogs, hazards, front fog spot, front main spot, rear fog)
Ta
steve

[Gordon Caro]

Steve,
Try looking at SWF rocker switches.
Gordon

[hollytree]

Gordon Thanks
I have, but cant find anyone/anywhere that sells them now

[LPH_UK]

Modular Rocker Switches | Auto-Electrical & Wiring - Dun-Bri Group

[hollytree]

Modular Rocker Switches | Auto-Electrical & Wiring - Dun-Bri Group

Thanks. Now to get the old dash out.

[retroracer]

I bought a set for my project from here: https://www.carbuilder.com/products/...574fc071&_ss=c

They look like the one in your first post. They are smaller than the original Italian ones, but there is a decent selection available.

- Tony

[hollytree]

Thanks. I looked at them, but they dont have the configurations I need.
I bought my originals and the little tiles from CBS, but they they dont seem to have them anymore

[hollytree]

Leigh
Thanks
They had the switches i needed.
Dash and dash loom out. Off to Halifax tomorrow to get a CAD file made up and then panel cut
https://www.dun-bri.com/catalogue/El...ocker-Switches

[hollytree]

I took my fake carbon weave dash panel to WaterJet at Halifax and Carl made a CAD copy.
He then cut a 3mm aluminium copy of it. We then swapped the major and minor gauge positions like the original cars and he then cut that.
Both panels took about 15 mins to cut with 60,000 psi water.
I am going for the major dials to the side look