My original shell/wheels I have stick out just a little bit. The fronts are fine, but would prefer to look kind of proper and have all wheels the same.
But I do like the wheel sticking out of the arches look.
I think I might still have the same problem with the ET20, since the manual specifies an 8" zero offset on the rear!
I do have the extended rear arches, but was trying to avoid doing any major bodywork changes until after passing IVA, as I am still unsure if I am going to go that direction.
If I can get at least a 9" underneath the rear, which I think should be possible then I will not bother.
Reply With Quote
Bookmarks